Table of Contents
Advertisement
How to install our products right...the first time.
1.
2.
3.
procedure
What's the first thing I should do?
The first thing you should do is read this user's manual. It contains important
information which will make configuration and setup much easier.
Here are some precautions you should follow when installing your mother-
board:
(1) Ground yourself properly before removing your motherboard
(2) Hold the motherboard by its edges and do not touch the bottom of
(3) Avoid touching motherboard components, IC chips, connectors,
(4) Avoid touching pins of memory modules and chips.
(5) Place motherboard on a grounded antistatic surface or on the
DO NOT APPLY POWER TO THE BOARD IF IT HAS BEEN DAMAGED!
Press down on any of the socket ICs if it appears that they are not properly
seated (the board should still be on an anti-static mat). Do not touch the
important!
bottom of the board. Remember, don't take any electronic device out of its
protective bag until you are ready to actually install it into the computer case.
If you do not ground yourself, you risk zapping the motherboard or adapter
card. Subsequent problems may not arise immediately because electrostatic
discharge damage, unlike physical damage, causes the device to fail over time.
Install the motherboard into your case.
Follow the instructions provided by the case manufacturer for proper installa-
tion guidelines. TYAN recommends that you use only one screw to hold down
the motherboard. The rest of the mounting holes should be used for the plastic
standoffs. If your case does not have a hole for a standoff, simply cut off the
bottom of the plastic standoff so that the flat portion rests on the metal. The
adapter cards and the screws holding them down will keep your board flat. The
fastening screw should not short any of the traces on the motherboard. Make
certain that you do not overtighten the screw, as it will damage the mother-
board and possibly break internal traces in the surrounding area. The hole you
http://www.tyan.com
from the antistatic bag. Unplug the power from your computer
and then touch any metal part on the computer case. (Or wear a
grounded wrist strap.)
the board.
and leads.
antistatic bag.
11
Advertisement
Table of Contents
