S E A - Allis-Chalmers WD Operating Instructions And Repair Parts Illustrations

The drawbar of drawn implement should be
adjusted to meet the requirements of the load.
(Refer to hitching height, implement instruction
book.) The line of draft effects steering and
traction. It can also cause the drawn implement
to put excessive load on the tractor.
The pins may be removed from the sides of the
tractor drawbar and the drawbar allowed to
swing. This will allow easier steering on sharp
turns with heavy loads. The tractor drawbar may
be raised or lowered, by removing the pins in the
bail support and reinstalling in the desired
position.
The drawbar is adjustable in length and should
be set to extend 14" beyond the end of the P.T.O.
shaft when used with the P.T.O. Use short
position for all drawbar work when P.T.O. is not
used. Drawbar must be perfectly free to,slide
when using drawbar control. When drawbar
control is not used keep drawbar clamp tightened
to eliminate wear on drawbar and keep universal
joints in alignment.
The seat is adjustable. There are three positions
1 - l/2 " anart. Select the position most convenient
for operator.
DRAWBAR
SEAT
27
SETTING ~