Allis-Chalmers WD Operating Instructions And Repair Parts Illustrations page 10

HYDRAULIC CO
GEAR SHIFT LEVER
AMMETER \
BREAK IN PERIOD - The tractor engine is as-
sembled and tested and ready for work, how-
ever for best results operate tractor under
medium loads for the first 10 to 20 hours of
operation.. If possible it should be operated
at full governed r.p.m. of engine. If necessary
use a lower gear to keep from overloading
engine. In cold weather the oil should be
changed after the first 20 to 30 hours of
operation. However if the proper temperature
is maintained at all times the lubricating
interval outlined in lubrication guide may be
followed.
STARTING ENGINE
1. Before starting tractor make certain that all
points of care and lubrication outlined under
daily, weekly or 30 day check have been ser-
viced as specified.
2. Close radiator shutter by turning screw crank
located on right hand side of tractor.
OPERATING INSTRUCTIONS
3. If gasoline is to be used open valve under
valve under small tank. Move throttle control
weather hold clutch pedal down until engine
4. Pull out magneto switch on instrument panel.
5. Pull carburetor choke rod located at right
6. Pull out on starter pull rod located on left
side of steering column. Engage starter
firmly to insure good switch contact. Release
immediately when engine starts, When engine
has turned one complete turn, push choke rod
forward, If weather is extremely cold more
choking may be necessary.
large tank. If low octane fuel is used open
lever down about one fourth of quadrant.
Place gear shift in neutral position. In cold
starts to relieve starter load.
side of steering column.