Table of Contents
Advertisement
5. Route the power cord toward a dedicated power source. Use the provided
cable straps to secure the power cord along the way. If the power cord must
exit the rack to connect to a power source, use the openings in the rack.
Attention:
v You must disconnect the main input power before you connect or disconnect
the input power cord of the PDU.
v You are responsible for making sure that only a Licensed Electrician installs
or removes the PDU power cable from the DC Power source. All National
and Local building code requirements must be met. IBM service technicians
are not Licensed Electricians.
6. Connect the power cord to a properly wired and grounded dedicated power
source (see "Connecting input power" on page 23 for information); then, you
can connect servers or rack PDUs in the rack to the power outlets on the PDU.
7. Route all the other power cords neatly and secure the power cords with cable
straps.
Chapter 2. Installing the 1U PDU vertically in a rack
15
Advertisement
Table of Contents
