Table of Contents
Advertisement
Installation requirements
You will need the following tools to install the PDU in a rack:
v One Phillips screwdriver
v One 10 mm (11/32 in.) wrench
v One cage-nut-insertion tool or flat-blade screwdriver (for installing cage nuts in
You can install a 1U PDU vertically in the side of a rack or horizontally within 1U
of EIA mounting space in a rack.
v For vertical mounting instructions of the 1U PDU, see Chapter 2, "Installing the
v For horizontal mounting instructions of the 1U PDU, see Chapter 3, "Installing
Inventory checklist
The following parts come with the PDU.
Note: The illustrations in this document might differ slightly from your hardware.
v The PDU (with an attached power cord)
v Two vertical-mounting brackets (for all racks)
v Two short mounting brackets (for horizontal mounting in all racks; for vertical
1. One U is equal to 4.45 cm (1.75 in.)
some racks)
1U PDU vertically in a rack," on page 7.
the 1U PDU horizontally in a rack," on page 17.
mounting only in IBM Enterprise racks)
1
3
Chapter 1. Introduction
Advertisement
Table of Contents
