Table of Contents
Advertisement
INSTALLING WATER TRAY EXTENSIONS continued...
2) Next, install the front side tray extension (A) Fig.19. Align the engraved marks
(B) with the rail hooks (C), slightly tilt the tray and hook it onto the two rail hooks
and under the supports (D).
3) Finally, install the rear side tray extension (A) Fig.20 onto the front side tray
extension (B). Slightly tilt the tray and insert its hooks into the two openings in
the front side tray extension (B). Lower the tray, then align and snap tray into
the hole in the rear tray extension (C).
ADJUSTMENTS
MAKING BEVEL CUTS
1) This Tile saw can make bevel cuts from 0-45
slide the work table away from the blade to prevent any blade damage.
2) Loosen the bevel lock handle (A) Fig.21.
3) Tilt the head to the desired position between 0-45
desired angle, retighten bevel lock handle.
ADJUSTING DEPTH OF CUT AND DEPTH STOP
1) The depth of cut adjustment knob (A) Fig.22 sets the height of the entire head
and can be used to cut at a set depth. Loosen adjustment knob (A) to raise the
head to clear the table. For normal cuts completely lower head and tighten
adjustment knob (A).
2) The depth stop controls the maximum depth of cut. If the blade cuts too deeply
or not deeply enough, loosen depth stop knob (B) Fig.22, adjust the depth stop
(C), retighten depth stop knob (B).
ASSEMBLY & ADJUSTMENTS
0
, before adjusting the head angle
0
. Once head is set at the
FIGURE 19
FIGURE 20
FIGURE 21
FIGURE 22
Advertisement
Table of Contents
