GE JGRP20 Owner's Manual page 23

Care and Cleaning
Control Panel
It's a good idea to wipe the control panel after each use
of the oven. Clean with mild soap and water or vinegar
and water, rinse with clean water and polish dry with a
soft cloth.
Lift-Off Oven Door
The oven door is
removable, but it is heavy.
You may need help
removing and replacing the
door. Do not lift the door by
the handle. This can cause
the glass to break or can
cause damage to the door.
To remove the door, open
it a few inches to the
special stop position that
will hold the door open.
Grasp firmly on each side
and lift the door straight up
and off the hinges.
NOTES:
the oven door frame as the hinge could snap back and
pinch fingers.
towels or empty paper towel rolls to prevent pinched
fingers and chipping the porcelain enamel on the frame.
To replace the door, make sure the hinges are in the
the door squarely over the hinges. Then lower the door
slowly and evenly over both hinges at the same time. If
the hinges snap back against the oven frame, pull them
back out.
Stainless Steel Surfaces
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
49-80713 Rev. 2
Lift the door straight up and off
the hinges.
Do not use abrasive cleansers, strong liquid cleaners,
plastic scouring pads or oven cleaners on the control
vinegar and hot water works well.
To clean the inside of the door:
in the door .
the self clean cycle, you do not need to clean this by
hand. Any soap left on the liner causes additional stains
when the oven is heated.
soap-filled plastic scouring pad.
To clean the outside of the door:
and front of the oven door. Rinse well. You may also
use a glass cleaner to clean the glass on the outside of
the door.
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When the surface is cool, clean and rinse.
vinegar and hot water works well.
To inquire about purchasing stainless steel appliance
cleaner or polish, or to find the location of a dealer nearest
you, please call our toll-free number:
GEAppliances.com
The gasket is designed with a gap
at the bottom to allow for proper air
circulation.
Do not rub or clean the door
resistance to abrasion.
If you notice the gasket becoming
worn, frayed or damaged in any way
or if it has become displaced on the
door, you should have it replaced.
23