Table of Contents
Advertisement
Installation
This section describes the installation and setup of the DTP2 T 203 switcher. Topics include:
•
•
•
•
Installation Overview
To install and set up the DTP2 T 203 switching transmitter:
1.
2.
3.
4.
Installation Overview
Rear Panel Features
Wiring Connections
Securing an HDMI Connector
Turn off all equipment and disconnect from the power source.
Mount the switcher (optional) on a rack shelf or furniture (see
DTP2 T 203
on page 64).
Connect HDMI or DP input sources to one or more of the DTP2 T 203 inputs. The
default (Extron) EDID is present at each input and Hot Plug Detect (HPD) is actively
controlled on each input.
NOTE: LockIt cable lacing brackets are provided to secure the HDMI cables to
the rear panel ports to reduce stress on the HDMI connectors and prevent signal
loss due to loose cable connections (see
page 15).
Connect an RJ-45 DTP or HDBT receiving device to the output connector (see
figure 2,
E
, on the next page). Set the DTP/HDBT switch (
switch (
D
).
•
If the receiving device is in the Extron DTP2 series, set the DTP/HDBT switch (
to DTP, and the SEND POWER switch (
If the receiving device is in the Extron Legacy DTP series, set the DTP/HDBT
•
switch (
F
) to DTP, and the SEND POWER switch (
position.
•
If the receiving device is HDBaseT enabled, set the DTP/HDBT switch (
HDBT, and the SEND POWER switch (
ATTENTION:
•
Position these switches (see figure 2,
appropriate device to the TP connector. Failure to comply can damage the
endpoint.
•
Positionnez les sélecteur (voir figure 2,
l'appareil approprié au connecteur TP. Ne pas respecter cette procédure
pourrait endommager le point de connexion.
NOTE: Use the provided LockIt cable lacing brackets to secure the HDMI cables to
the port to reduce stress on the HDMI connectors and prevent signal loss due to
loose cable connections (see
Securing an HDMI Connector
D
) to the Up (SEND POWER) position.
D
) to the Down (OFF)
D
) to the Down (OFF) position.
D
and
F
) BEFORE connecting the
D
F
) AVANT de connecter
et
Securing an HDMI Connector
DTP2 T 203 • Installation
Mounting the
on
F
) and SEND POWER
F
)
F
) to
on page 15).
5
Advertisement
Table of Contents
