Electrical Connection - Rinnai RB-3011E-CB Operation & Installation Manual

IMPORTANT: Installation must be carried out according to the manufacturer's instructions. Incorrect installation
may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility.
Before carrying out any work on the electrical section of the appliance, it must be disconnected from the mains.
Connection to a good earth wiring system is absolutely essential.
The manufacturer accepts no responsibility for any inconvenience caused by failure to comply with this rule.
ELECTRICAL REQUIREMENTS
• Connection to the electric power supply must be carried out by a qualified technician and following the
appropriate safety regulations.
• The appliance must be connected to the mains checking that the voltage corresponds to the value given in the
rating plate and that the electrical cable sections can withstand the load specified on the plate.
• If the hob is supplied without plug, fit a standard device which is suitable for the power absorbed by the
appliance and in conformity with the local rules in force.
• A suitable isolating switch providing full disconnection from the mains power supply shall be incorporated in the
permanent wiring, mounted and positioned to comply with the local wiring rules and regulations. The isolating
switch must be of an approved type and provide a 3 mm air gap contact separation in all poles.
• The power supply cable must not touch the hot parts and must be positioned so that it does not exceed 50 ℃
above ambient.
• Once the appliance has been installed, the power switch must always be in a accessible position.
N.B. For connections to the mains power supply, never use adaptors, reductions or multiple power points as
these may overheat and catch fire.
In the event that installation should require modifications to the mains supply wiring system, it is recommended
that a qualified technician be called to carry out substitution.
The technician will also have to verify that the cross-section of the electric cables on the power point match the
appliance's power rating.
If the hob surface is cracked disconnect the appliance from the mains and contact the after-sales service.
Replacing the power cord must be done by a qualified electrician in accordance with the instructions
supplied by the manufacturer and in compliance with established electrical regulation.
Descriptions and illustrations in this booklet are given as simply indicative. The manufacturer reserves
the right, considering the characteristics of the models described here, at any time and without notice,
to make eventual necessary modifications for their construction or for commercial needs.

ELECTRICAL CONNECTION

13