Advertisement
I. Finishing the Installation
1 .
Route the WHITE/BLACK antenna wire (8" wire extending from the side of
the module) away from the module and surrounding harnesses. Keep the
antenna as straight as possible. Make sure the end of the antenna does not
make contact with metal.
Note: The antenna is cut to the appropriate length to ensure optimum
performance. Do not cut or add wire to the antenna.
2.
Using the supplied short tie wraps, secure the system wiring harness to
existing wiring harnesses so that they are concealed and clear of any
moving vehicle components.
3.
Replace the left lower dash trim panel.
4.
Place the Owner's Manual in glovebox.
Installation is now complete.
J. Additional Transmitter Programming
(5
1.
Open driver's door.
2.
Press and hold the programming button.
In fifteen (15) seconds the door locks will cycle three (3) times to indicate
that the system is in the transmitter programming mode. DO NOT release
the programming button.
3.
Press the LOCK button two (2) times on one of the transmitters.
The door locks will cycle each time a button is pressed to confirm
programming.
4.
Repeat step 3 for the second transmitter.
5.
Release the programming button and turn the ignition key to the "OFF"
position.
6.
Go back to Section E.
Advertisement
