How To Remove The Controller From The Vxi Chassis - National Instruments VXIpc 770 Series User Manual

How to Remove the Controller from the VXI Chassis

© National Instruments Corporation
2
1
1 VXIpc-872B Controller
Figure 2-1. VXIpc-872B Controller Installed in a VXI Chassis
The VXIpc 770/870B Series controllers are designed for easy handling.
To remove the controller from the VXI chassis, complete the following
steps:
1. Shut down all applications and the operating system.
2. Turn off power.
3. Disconnect devices from the front panel ports as your system
configuration requires.
4. Remove the retaining screws in the controller front panel.
5. Push the upper ejector handle up and the lower ejector handle down
until the controller pops out of the backplane connectors.
6. Slide the controller out of the chassis.
2 VXI Chassis
2-3
Chapter 2 Installation
VXIpc 770/870B Series User Manual