Configuring The Vxipc 700 Series; How To Remove The Metal Enclosure; Table 4-1. Vxipc 700 Series Hardware Default Settings - National Instruments VXIpc 800 Series User Manual

Configuring the VXIpc 700 Series

How to Remove the Metal Enclosure

© National Instruments Corporation
Table 4-1 lists the factory-default settings and options for the onboard
jumpers.

Table 4-1. VXIpc 700 Series Hardware Default Settings

Jumper/
Switch
W1 Enable automatic Slot 0
detection
W3 Normal CMOS operation
W6 Enable Ethernet EEPROM
configuration
W10 Enable MITE
self-configuration
W7 MITE user configuration
W12 No termination on external
trigger input
This section describes how to configure the following options on the
VXIpc-700.
• VXIbus Slot 0/Non-Slot 0
• Trigger Input Termination
• EEPROM
• Installed system RAM
The VXIpc-700 is housed in a metal enclosure comprised of a top and
bottom cover to improve EMC performance and to provide easy
handling. You must remove the top cover to change many of the switch
and jumper settings. You must also remove the top cover to change the
amount of DRAM installed on the module.
Chapter 4 VXIpc 700 Series Configuration and Installation
Default
Setting
4-3
Optional
Setting
Force Slot 0;
Force Non-Slot 0
Clear CMOS
Disable Ethernet EEPROM
configuration (uses default
power on values)
Disable MITE
self-configuration
MITE factory configuration
Terminate external trigger
input to 50 Ω
VXIpc 800/700 Series User Manual