Configuring The Vxipc 700 Series; How To Remove The Metal Enclosure; Table 3-1. Vxipc 700 Series Hardware Default Settings - National Instruments VXIpc 700 Series User Manual

Configuring the VXIpc 700 Series

How to Remove the Metal Enclosure

© National Instruments Corporation
Table 3-1 lists the factory-default settings and options for the onboard
jumpers.

Table 3-1. VXIpc 700 Series Hardware Default Settings

Jumper Default Setting
W1 Enable automatic Slot 0
detection
W3 Normal CMOS operation
W6 Enable Ethernet EEPROM
configuration
W10 Enable MITE
self-configuration
W7 MITE user configuration
W12 No termination on external
trigger input
This section describes how to configure the following options on the
VXIpc 700 Series:
• VXIbus Slot 0/Non-Slot 0
• Trigger Input Termination
• EEPROM
• Installed system RAM
The VXIpc-700 is housed in a metal enclosure comprised of a top and
bottom cover to improve EMC performance and to provide easy handling.
You must remove the top cover to change many of the switch and jumper
settings. You must also remove the top cover to change the amount of
DRAM installed on the module.
Remove the top cover by removing the 10 screws that attach it to the
module.
Chapter 3 VXIpc 700 Series Configuration and Installation
3-3
Optional Setting
Force Slot 0;
Force Non-Slot 0
Clear CMOS
Disable Ethernet EEPROM
configuration (uses default
power on values)
Disable MITE
self-configuration
MITE factory
configuration
Terminate external trigger
input to 50 Ω
VXIpc 700 Series User Manual