Installation - Tripp Lite PDUMH15AT Owner's Manual

Installation

Mounting the PDU
The PDU supports four primary mounting
configurations: 1U Rack, 0U Rack, Wall and
Under-Counter.
Note: Regardless of configuration, the user must determine the
fitness of hardware and procedures before mounting. The PDU
and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all
applications. Exact mounting configurations may vary.
1-1 1U Rack Mounting. Attach the PDU to the
rack by inserting four user-supplied screws
through the PDU mounting brackets
the mounting holes of the rack rail as shown.
1-2 0U Rack Mounting. Remove the screws
attaching the mounting brackets to the PDU,
change the orientation of the brackets as shown
and reattach the brackets. Use only the screws
supplied by the manufacturer or their exact
equivalent (#6-32, 1/4" flat head). Attach the
PDU vertically by inserting two or more user-
supplied screws through the PDU mounting
A
brackets and into mounting points in the rack
B
or rack enclosure.
1-3 1-4
Wall or Under-Counter Mounting.
Remove the screws
C
brackets to the PDU, change the orientation of
the brackets as shown and reattach the brackets.
Use only the screws supplied by the
manufacturer or their exact equivalent (#6-32,
1/4" flat head). Attach the PDU to a stable
mounting surface by inserting two or more
user-supplied screws
A
mounting brackets
B
the mounting surface.
Connecting the PDU
The PDU includes two AC power inputs:
Primary and Secondary. The Primary input cord
is permanently attached to the rear of the PDU.
The Secondary input cord is detachable and
connects to the IEC power inlet
the PDU (PDUMH15AT - IEC-320-C14 inlet;
PDUMH20AT - IEC-320-C20 inlet).
and into
B
attaching the mounting
through the PDU
and into secure points on
2
at the rear of
A
C
1-1
B
1-2
B
1-3
1-4
2
3
B
A
C
C
B
A
PDUMH15AT
A
C
A
PDUMH20AT