Xerox WorkCentre PE114e Service Manual page 65

6.7 Consumables and Replacement Parts
The cycle period outlined below is a general guideline for maintenance.
The example list is for an average usage of 50 transmitted and received documents per day.
Environmental conditions and actual use will vary these factors.
The cycle period given below is for reference only.
COMPONENT
Pick-up Roller
Paepr Feeding Roller(Friction Pad)
Transfer Roller
Fuser
Toner Cartridge
6.8 The LCD Status Display by Each Error
LCD
Door Open The front or rear cover is not securely
latched.
[JAM 1] or The toner cartrige is not installed.
[No Cartridge]
Low Heat Error There is a problem in the fuser unit.
Open Heat Error
[Over Heat]
[LSU Error] A problem has occurred in the LSU
(Laser Scanning Unit).
No Paper The paper tray has run out of paper.
[Add Paper]
Paper Jam 0 Paper has jammed in the feeding area of
Open/Close Door the paper tray.
Paper Jam 1 • Paper has jammed in the fuser area.
Open/Close Door
• A paper jam has occurred in the manual
feeder or the machine detects non-
feeding from the manual feeder.
Paper has jammed in the paper exit area.
Paper Jam 2
Check Inside
Samsung Electronics
60,000 Pages
60,000 Pages
60,000 Pages
60,000 Pages
Original 1,000 Pages
Meaning
Alignment & Adjustments
REPLACEMENT CYCLE
Replacement 3,000 Pages
Solutions
Close the cover until it locks into place.
Install the toner cartridge.
Unplug the power cord and plug it back in.
(Tech Mode Reference)
Unplug the power cord and plug it back in.
(Tech Mode Reference)
Load paper in the paper tray.
Clear the jam.
• Clear the jam.
• Clear the jam.
Clear the jam.
Service Manual Service Manual
6-7 6-7