Status Leds Model Gss116E; Back Panel Model Gss116E - NETGEAR GSS108E Hardware Installation Manual

8-Port and 16-Port Gigabit Ethernet (PoE+) Smart Managed Plus Click Switch
From the left to the right, the front panel contains the following components:
• Sixteen independent 10/100/1000BASE-T RJ-45 ports, each with a left LED and a
right LED that, combined, indicate link, speed, and activity (see Status LEDs model
GSS116E on page 15).
• A rectangular Power LED (see Status LEDs model GSS116E on page 15).
• An AC power receptacle, placed at a 45-degree angle. (The switch integrates a fixed,
internal power supply unit.)

Status LEDs model GSS116E

The following table describes the RJ-45 port LEDs for ports 1–16 and the Power LED
on the front panel of model GSS116E. The Power LED is located to the right of port 16.
Table 2. Front panel LEDs for model GSS116E
LEDs
Left port LEDs Right port LEDs
Solid green Off
Blinking green Off
Off Solid green
Off Blinking green
Off Off
Power LED Solid green
Off

Back panel model GSS116E

The back panel does not contain any components other than a recessed Factory Default
button (see Factory Defaults button on page 18).
The following figure shows the back panel.
Figure 4. Back panel model GSS116E
Hardware Overview
Description
A valid 1000 Mbps Ethernet port link is established.
The port is transmitting or receiving packets at 1000 Mbps.
A valid 10 Mbps or 100 Mbps Ethernet port link is established.
The port is transmitting or receiving packets at 10 Mbps or 100 Mbps.
No Ethernet link port is established.
The switch is powered on.
Power is not supplied to the switch.
15 Hardware Installation Guide