Table of Contents
Advertisement
IDENTIFICATION OF CONTROLS & CONNECTIONS
1.
ANTENNA
The Quick Assist II contains an internal antenna. This
antenna radiates radio signals.
2.
TELEPHONE JACK
The modular telephone jack provides for a temporary
connection to a standard pulse or rotary mode
telephone unit, used to program Quick Assist II voice
messages and other settings. Refer to FIG-2, below.
CAUTION:
Do not connect the Quick Assist II to a line
from the telephone company; doing so will
damage the unit and void the manufacturer's
warranty.
3.
BATTERY HOLDER
The battery holder accommodates the six (6) standard
"AA" alkaline cells That are required to power the
Quick Assist II.
IMPORTANT: Always install a fresh set of alkaline
batteries before programming the Quick
Assist II.
4.
SWITCH #1 TERMINALS
Switch #1 terminals connect to the unit's front panel
(Customer) push-button. When this push-button is
pressed and released, the Quick Assist II transmits
a voice message (typically, a Customer-assistance
message).
5.
SWITCH #2 TERMINALS
Switch #2 terminals are connected together for the
Quick Assist II. (a Re-set button version is not
available).
FIG-2: CONTROL & CONNECTION LOCATIONS
O
WNER
D
ESK
SWITCHED
M
O D E
TO
TELEPHONE JACK
(I
O
-
M
WNER
SUPPLIED
ODULAR
T
C
:
ELEPHONE
ORD
DO NOT
CONNECT TO
,
TELEPHONE LINE
BUT TO A
.
TELEPHONE SET ONLY
6
External Power
Input Terminals
7
Customer Service
Push-button
Connection
4
Switch #1
Terminals
2
www.TwoWayRadioEquipment.com | (800) 878-7829 | Sales@TwoWayRadioEquipment.com
-
S
S U P P L I E D
TANDARD
T
S
,
ELEPHONE
ET
P
D
TO
ULSE
IALING
Q
A
II
UICK
SSIST
,
2).
TEM
5
Switch #2
Terminals
Standard
Modular
Telephone Jack
6.
EXTERNAL POWER TERMINALS
Refer to the page 10 for information to connect an
external 12 Volt DC power supply to these terminals.
7.
FRONT PANEL (CUSTOMER SERVICE) PUSH-BUTTON
NOT SHOWN ON DIAGRAM
When this push-button is pressed and released, the
Quick Assist II transmits a voice message (typically a
Customer-service message).
8.
TRANSMITTER BANDWIDTH SELECT JUMPER
Do not remove this jumper. As described on
page 9 this jumper controls selection of wide or
narrow bandwidth.
9.
BATTERY TYPE SELECTOR
Do not remove this jumper. As described on
page 10 this jumper controlsIt controls charging
the optional NiCad batteries.
10. COMPRESSED/NOT-COMPRESSED AUDIO SELECTOR
Do not remove this jumper. The Quick Assist II
can be used with two-way radios that use "companded
audio." For radios with Companded Audio -place
the jumper in the COMP position. For radios without
Companded Audio - place the jumper in the NON-
COMP position. To determine if your radio uses
companded audio, call Ritron or your radio supplier.
IMPORTANT:
Do not remove any other fasteners or
further disassemble the Quick Assist II unit; doing so risks
damage to the unit and voiding the manufacturer's warranty.
9
Battery Type Selector
3
Battery
Holder
10
Compressed/Not-Compressed
Audio Select Jumper
qtm9322b.pm5
8
Transmitter Bandwidth
Select Jumper
1
Antenna
— 3 —
Advertisement
Table of Contents
