Controls & Connectors - Ritron Quick Talk Basic Owner's Manual

qtm9322b.pm5
IDENTIFICATION OF CONTROLS AND CONNECTIONS
1 ANTENNA CONNECTOR
The antenna radiates radio signals. Before using Quick
Talk, make sure the antenna is fastened securely to this
connector. See page 12.
2 TELEPHONE JACK
The modular telephone jack provides temporary con-
nection to a standard pulse or rotary mode telephone
unit, which is used by the owner to program Quick Talk
voice messages and other settings.
WARNING: Do not connect the Quick Talk to a line
from the telephone company; doing so
will damage the unit, and void the
manufacturer's warranty.
3 BATTERY HOLDER
The battery holder accommodates the six (6) standard
"AA" alkaline cells required to power the Quick Talk.
NOTE: Always install a fresh set of alkaline batteries
before programming the Quick Talk.
4 SWITCH #1 TERMINALS
These terminals are for connection to a user-supplied
switch. The Quick Talk transmits voice messages
determined by the state of this switch.
5 SWITCH #2 TERMINALS
These terminals are for connection to an optional user-
supplied switch. This manual describes how to use
Switch #2 as an On/Off switch to enable or disable the
Quick Talk transmitter; see page 11. Other program-
mable features of Switch #2 are covered in the
Advanced Features Owner's Manual (RQT-UM2).
FIGURE 1: CONTROL & CONNECTION LOCATIONS
O -
WNER
T
ELEPHONE
P D
ULSE
Q
TO UICK
TELEPHONE JACK
O -
WNER SUPPLIED
M T C :
ODULAR ELEPHONE ORD
DO NOT
CONNECT TO
,
TELEPHONE LINE BUT TO
.
A TELEPHONE SET ONLY
2
Standard Modular
Telephone Jack
Page 2 For assistance, call RITRON at 1-800-872-1872, or go to < http://www.ritron.com >
S D
SUPPLIED TANDARD ESK
S ,
ET SWITCHED TO
M
IALING ODE
(Back of Quick Talk Cover Assem.)
T
ALK
.
8
9
6 EXTERNAL POWER TERMINALS
Refer to the Advanced Features Owner's Manual
(RQT-UM2), for information about connecting an
external 12 Volt DC power supply to these terminals.
7 WATERTIGHT STRAIN RELIEF CABLE FITTING
The cable to your external switches passes through
this fitting. When the strain relief fitting is used with
recommended cable sizes, it provides a water-resistant
enclosure. Do not overtighten this fitting.
NOTES: Use Radio Shack Telephone Station Wire,
6-conductor, solid 24-AWG In-wall Type CM,
Cat. No. 278-874, or round cable of equiva-
lent size (0.114 to 0.250 inches in diameter).
If you cannot find suitable wire, call Ritron
at 1-800-872-1872.
8 TRANSMITTER BANDWIDTH SELECT JUMPER
Do not remove this jumper. See the Advanced
Features Owner's Manual (RQT-UM2).
9 BATTERY TYPE SELECTOR
Do not remove this jumper. As described in the
Advanced Features Owner's Manual (RQT-UM2), this
jumper controls charging of optional NiCad batteries.
NOTE: Do not remove any other fasteners or further
disassemble the Quick Talk unit; doing so
risks damage to the unit, and the voiding of
the manufacturer's warranty.
+
+
+ —
SWITCH 2
+
+ —
+
SWITCH 1
+
+ —
EXT. PWR.
+
7
Strain Relief Fitting
(For wire to External Switch)
1
Antenna Connection
(Antenna shown on page 12.)
3
Battery Holder
F S J
ACTORY HORTING UMPER
5
Switch #2
Wiring Terminals
4
Switch #1
Wiring Terminals
6
External Power
Input Terminals