Identification Of Quick Assist Controls And Connectors; Fig-1: Controls & Connectors - Ritron RQA-152M Installation And Operating Instruction Manual

I Q
DENTIFICATION OF UICK
1 Battery Holder
The battery holder accommodates the six (6) standard AA
alkaline cells required to power the Quick Assist
NOTE: Always install a fresh set of alkaline batteries
before programming the unit.
2 Front Panel LED
The red front panel LED is lit whenever the Quick Assist
is transmitting a message.
3 SMB Antenna Connector
This connects the internal antenna to the radio printed
circuit board.
4 External Audio Input
Allows input to the Quick Assist
external audio source, such as the Line Out audio from
your computer.
5 Microphone
Microphone for recording voice messages.
FIG-1: CONTROLS & CONNECTIONS
3
4
5
8
7
6
________________________________________________________________________________________________
For assistance, call RITRON at 800-872-1872, or go to
®
A C C
SSIST ONTROLS AND
®
.
®
voice recorder from an
2
9
..............................................................................................
ONNECTIONS
6 USB Programming Connector
Connects the Quick Assist
computer for programming.
7 Record Button
Press this button to initiate voice recording.
8 Internal Antenna
®
The internal antenna radiates radio signals.
9 Front Panel Push Button
When the front panel push button is pressed the Quick
Assist
sealed push button provides a water-resistant enclosure.
10 Battery Connector
In-line connector between the printed circuit board and the
battery holder.
IMPORTANT: Do not remove any other fasteners or
further disassemble the Quick Assist
damage to the unit and voiding the manufacturer's
warranty.
1
®
to the USB port on your
®
transmits your pre-recorded voice message. This
10
www.ritron.com
®
unit; doing so risks
12