Table of Contents
Advertisement
Important:
Damages caused by the disregard of this user manual are not subject to
warranty. The dealer will not accept liability for any resulting defects or
problems. Make sure the electrical connection is carried out by qualified
personnel. All electrical and mechanical connections have to be carried out
according to the European safety standards.
2. Before usage
2.1. Carton
1 x Flatbeam Duo
1 x Power Cable with Plug
1 x DMX Input Cable
1 x User Manual
2.2. Unpacking
Every Flatbeam Duo has been thoroughly tested and has been transported in perfect operating
condition. Carefully check the carton for damages that may have occurred during the transport. If
the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all
accessories necessary to operate the unit has arrived intact.
2.3. AC Power
This fixture has an auto-switching power supply that can accommodate a wide range of input
voltages. The only thing necessary to do before powering on the unit is to make sure the line
voltage you are applying is within the range of accepted voltage. This fixture will accommodate
between 100V and 240V AC 50~60Hz. All fixtures must be powered directly off a switched circuit
and cannot be run off a rheostat.
3. Introduction
3.1. Features
-
3, 4, 5, 6 or 11 Channel DMX 512 Control Operating Modes.
3 Channel = RGB control
3 Channel = HSV control (hue, saturation and value)
4 Channel = RGB, Dimmer
4 Channel = RGBW Control
5 Channel = RGBW Dimmer
6 Channel = RGBW Dimmer Strobe
11 Channel = RGBW, ID, dimmer, strobe, autospeed, auto, custom programs, aso.
-
Light source 48 x 8W 4in1 High Power Leds
-
Lens: 51° Standard Lens
-
Material: aluminum body
-
Protection Rating: IP67
-
Power Consumption: 400W
5 / 21
Advertisement
Table of Contents
