Tripp Lite UT1250UL Specifications

WARRANTY REGISTRATION:

Specifications

MODEL NUMBER:
Series Number:
Agency Approvals:
AC Input Connection (for optional charging):
AC Output Connection:
INVERTER
Continuous Power (@ 20 C):
OverPower™ Peak Surge Power:*
Double Boost™ Peak Surge Power:*
Maximum Output AC Current (Continuous):
UL-Recognized DC Fuse Required:
DC Input Current @ Nominal V DC Full Load:
DC Input Volts (Nominal):
DC Input Voltage Range:
Output Volts (Nominal):
Output Frequency (Nominal):
Efficiency:
BATTERY CHARGER
Charging Capacity DC:
Input Current AC:
Acceptance Volts VDC:
Float Volts DC (Wet/Gel):
Input Volts (Nominal):
* OverPower duration (up to 1 hour). DoubleBoost duration (up to 10 seconds). Actual duration depends on battery age, battery charge level and ambient temperature. **Factory setting. The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice. This
product designed and engineered in the USA.
Minimum Recommended Cable Sizing Chart
Use in conjunction with DC wiring connection instructions in the Battery Connection section.
Inverter DC Volt: 12
Watts 6 4
500 15 ft 25 ft
700 11 ft 18 ft
1000 N/R 12 ft
2000 N/R N/R
3000 N/R N/R
†
N/R = Not Recommended. NOTE: Acceptable power is directly related to cable length (i.e. - the
shorter the cable, the better the performance)
Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number
can be found on the product nameplate label, along with all required approval markings and information. When requesting compliance information for this
product, always refer to the series number. The series number should not be confused with the marking name or model number of the product.
register online today for a chance to win a FREE Tripp Lite product—www.tripplite.com/warranty
UT750UL
AGAP5088
cTUVus
Input Cord
Two GFCI Outlets
750
1125
1500
6.3 A
One 80 A
72 A
12 VDC
10-15 VDC
120 VAC, ± 5%
60 Hz, ± 0.5 %
88% to 94%, depending on
load and temperature
Selectable 45 A** / 11 A
9.3 A
Selectable 14.4V** /
14.2 V Wet** / Gel
13.3 V (13.6 V)
120 VAC
†
Wire Gauge
Twin 00 (2/0)
2 0 00 (2/0) (UT3012UL only)
39 ft 62 ft 79 ft 158 ft
28 ft 44 ft 56 ft 112 ft
20 ft 31 ft 39 ft 78 ft
N/R 16 ft 20 ft 40 ft
N/R 10 ft. 13 ft. 26 ft
1111 W. 35th Street Chicago, IL 60609 • (773) 869-1234 • www.tripplite.com
Copyright © 2005 Tripp Lite. All rights reserved.
UT1250UL
AGAP5217
cTUVus
Input Cord
Two GFCI Outlets
1250
1875
2500
10.4 A
One 200 A
127 A
12 VDC
10-15 VDC
120 VAC, ± 5%
60 Hz, ± 0.5 %
88% to 94%, depending on 88% to 94%, depending on
load and temperature load and temperature
Selectable 40 A** / 10 A Selectable 60 A** / 15 A
8.2 A
Selectable 14.4V** / Selectable 14.4 V** /
14.2 V Wet** / Gel
13.3 V (13.6 V)
120 VAC
Note on Labeling
V~
: AC Voltage
WARRANTY REGISTRATION
Visit www.tripplite.com/warranty today to register the warranty for
your new Tripp Lite product. You'll be automatically entered into a
drawing for a chance to win a FREE Tripp Lite product!*
* No purchase necessary. Void where prohibited. Some restrictions apply. See website for details.
UT2012UL UT3012UL
AGAP5290 AGAP4669
cULus
Input Cord Hardwire AC Input
Two GFCI Outlets Hardwire AC Output
2000
3000
4000
16.7 A
Two 200 A Two 275 A
190 A
12 VDC
10-15 VDC 10-15 VDC
120 VAC, ± 5% 120 VAC, ± 5%
60 Hz, ± 0.5% 60 Hz, ± 0.5%
99% to 94%, depending on
load and temperature
Selectable 140 A** / 35 A
12 A
Selectable 14.4 V** /
14.2 V Wet** / Gel 14.2 V Wet** / Gel
13.3 V (13.6 V) 13.3 V (13.6 V)
120 VAC
Two symbols are used on the RV labels.
V
: DC Voltage
cULus
3000
4500
6000
25 A
290 A
12 VDC
30 A
120 VAC
200511035 93-2512