Quick Installation - Tripp Lite SmartPro Rackmount SMX1500XLRT2U Owner's Manual

Quick Installation

Unplug computer's power cord
1
from both AC outlet and computer's
AC input.
Insert the female plug of com-
2
A
puter's cord into UPS's AC input.
Insert the male plug of computer's
cord into AC outlet.*
NOTE! after you plug the UPS into a live AC outlet, the UPS (in
"Standby" mode) will automatically charge its batteries,** but will not
supply power to its outlets until it is turned ON (see Step 3 below).
* See Specifications for circuit amperage requirements. ** The BATTERY
CHARGE LED will be the only LED illuminated.
Find one of the power cords that
3
came with the UPS.
cord's female plug into computer's
AC input. Insert the cord's male
plug into any of UPS's female output
receptacles.
Plug your equipment into the UPS.*
4
Plug your equipment into the UPS. Repeat step 3
above using the additional power cord(s) that came
with the UPS.
Note: Additional interconnection cords (C13 to C14) are available
from Tripp Lite. Call 773-869-1234 (Part # P004-006).
* Your UPS is designed to support only computer equipment. You will
overload the UPS if the total VA ratings for all the equipment you connect
exceeds the UPS's Output Capacity (see Specifications). To find your
equipment's VA ratings, look on their nameplates. If the equipment is
listed in amps, multiply the number of amps by 240 to determine VA.
(Example: 1 amp × 240 = 240 VA). If you are unsure if you have overloaded
the UPS's outlets, see "OUTPUT LOAD LEVEL" LED description.
Turn the UPS ON.
5
Press and hold the "ON/OFF/STANDBY" button for
one second. The alarm will beep once briefly after one
second has passed. Release the button.
Insert the
B
5
1
IEC320-C14 plug shown
A
2
B
3
4
5