Table of Contents
Advertisement
Quick Installation
Position your External Battery
1
Pack(s).
• If positioning multiple Battery Packs, place them side
by side or stack them no more than three high.
2
Position your Power Module.
• The Module may be stacked on top of your Battery
Packs or placed beside them.
Plug your External Battery Pack
3
into your Power Module's
External Battery Connector on
its back panel.
• For multiple Battery Packs, connect the first to the
Power Module, then daisy-chain the others: connect the
second to the first, the third to the second, and so on.
Plug your Power Module into a
4
L6-30 single-phase AC outlet on
a 30-amp dedicated circuit that
provides 220V to 240V at 50 Hz.
Plug your equipment into the
5
Power Module.
Turn your UPS ON.
6
• Set the System Switch on the UPS's back panel to the
"ENABLE" (RIGHT) position. (Figure 1a)
This switch activates the battery charger and microprocessor.
The "
" light will flash until you engage the ON/Standby
Switch to activate the "ON" mode.
• Engage the momentary ON/Standby Switch on the UPS's
front panel and release it to activate the "ON" mode and
supply power to the UPS receptacles. (Figure 2b)
Communications on Next Page...
BRANCH CIRCUIT #1
230VAC 10AMPS
00VA 4500W
M 50/60HZ 5000VA 3700W
CAUTION: DO NOT UNPLUG WHILE
50HZ 5000VA 3700W
OPERATING OR ARCING WILL OCCUR
36VDC 175 AMPS MAX
BRANCH CIRCUIT #1
230VAC 10AMPS
50/60HZ 5000VA 4500W
30VAC NOM 50/60HZ 5000VA 3700W
CAUTION: DO NOT UNPLUG WHILE
0VAC NOM 50HZ 5000VA 3700W
OPERATING OR ARCING WILL OCCUR
36VDC 175 AMPS MAX
1a.
Back panel
2b.
Front panel
3
Advertisement
Table of Contents
