Sony BRS-200 Operational Manual page 75

Technical Appendix
Setting menu Setting item
900
INPUT.. 920 NAME..
built in the BRS-200 can be named in four characters to register.
MENU
1. Press
921
2. Turn
3. Press
4. Turn
5. Turn
When you move the highlighting to the space next to the fourth character on
921 SIGNAL
RENAME (4-character definition to be
<=>
ASSIGN.. 922 XPT BTN
SIGNAL
NAME
INHIBIT
ADJUST.. 923 XPT BTN 1
Y-LEVEL
SETUP
C-LEVEL
PROC.. 924 SIGNAL
NAME
4:3 PROC
FS.. 925 SIGNAL
NAME
FS
SIDE.. 926 LUM
SAT
HUE
.
or to select the signal to be named.
to highlight a character.
to change the highlighted character.
to move the highlighting to the character to be changed.
IN 1, IN 2, IN 3, IN4, IN 5, IN 6,
IN 7, IN 8, IN 9, FM 1, FM 2,
MAT1, MAT2, CLBR
input)
1 o t 1 2
IN 1, IN 2, IN 3, IN 4, IN 5, IN
6, IN 7, IN 8, IN 9, FM 1, FM 2,
MAT1, MAT2, CLBR
(4-character indication)
Off, On
o t 1 2
0.50 to 1.50 (1.00) (in 0.01)
–10.0 to 10.0 (0.0) (in 0.5)
0.50 to 1.50 (1.00) (in 0.01)
IN 5, IN 9
(4-character indication)
WidZoom, Center,
Zoom
SDI1, SDI2, SDI3, SDI4, SDI5,
SDI6, SDI7, SDI8
(4-character indication)
Off, On
0.0 to 100.0 (in 0.1)
0.0 to 100.0 (in 0.1)
0.0 to 359.5 (in 0.5)
MENU
( )
921
75
Description
Allows you to register the name (in 4
characters) identifying each of the signals
input from the connectors on the Processor
Unit and frame memories, color mattes, and
color bars built in the switcher.
For details, see "To register the name of the
signal (menu page 921)" on page XXX.
A s s g i n s s g i n a s l o t h t e c o r s s
Disables operation of the selected cross-
point button when INHIBIT is set to On.
A d u j s s t h t e e l e v s l f o h t e s g i
correspond to the cross-point buttons.
Note
These adjustments are not available for DVI,
color matte, or frame memory signals.
Sets the process of the aspect ratio of the
signal input from IN 5 or IN 9 when the
optional BRSA-20DD1 is installed.
For details, see "Conversion between Input
Signal and Output Signal" on page XXX.
Note
These items can be set only when FORMAT
is set to HD on menu page 951.
Allows you to add FS (frame synchronizer)
to the input signal selected under SIGNAL.
Set FS to On for the connected device to
which external sync signal cannot be added.
Sets color matte for the side cut area for an
available signal.
The F1 to F3 controls and the joystick can
be used for the setting.
p - o t n i b t u o t n . s
n a s l h t t a