Napoleon Vector Series Installation Manual page 37

6.1 hard wiring connection
It is necessary to hard wire this appliance.
Permanently framing the appliance with an enclosure, requires the appliance junction box to be hard wired. This
appliance must be electrically connected and grounded in accordance with local codes. In the absence of local
codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70-1996 National
Electrical Code in the United States.
6.2 receptacle wiring diagram
Route power supply and optional LHAD kit through the outer fi rebox to the receptacle mounted on the bottom of
the appliance. For optional LHAD kit installation, please refer to the leafl et provided in the kit.
6.3 in the event of a power failure
If the battery holder/switch is equipped with batteries, the appliance will still have ON/OFF functions during a
power failure. Refer to "operation" section in the Owner's manual when communications between battery holder/
switch and remote have been lost. The battery holder/switch will emit a "beep" sound to confi rm programming
has been successful once power is restored. During a power failure, if the fi replace was on, the fl ame height will
stay at the setting prior to the failure. If off when the failure occurs and then turned on, the fl ame height will come
on at "HI". The fl ame height can then be controlled by the remote.
In most cases, your appliance will operate with simple functions available until power is restored. All other electri-
cal features / accessories will not work during a power failure.
L1
L2
To optional LHAD kit
venting installation
6.0 electrical information
Power Supply
Cable Connector
EN
37
W415-2034 / A / 10.18.19