BenQ AQCOLOR DesignVue PD Series User Manual page 15

•Connect the plug of the HDMI cable to the HDMI port on the monitor. Connect the other end of the
cable to the HDMI port of a digital output device.
•Connect the plug of the DP cable to the monitor video socket. Connect the other end of the cable to
the computer video socket.
•Connect the plug of the USB-C™ cable to the monitor video socket. Connect the other end of the
cable to the computer video socket.
After the monitor and the computer are powered on, if the image is not displayed, disconnect the DP cable.
Connect the monitor to any video source other than DP first. Go to
of the monitor and change the setting from
and re-connect the DP cable. To go to the OSD menu, see
2. Tighten all finger screws to prevent the plugs from accidentally falling out during use.
3. Connect the other end of the video cable to an appropriate port of a digital output source
(e.g., a computer).
3. Connect the headphone.
You may connect headphones to the headphone jack found on the back side of the monitor.
4. Connect USB devices.
1. Connect the USB cable between the PC and the monitor (via the upstream USB port at the
back). This upstream USB port transmits data between the PC and the USB devices connected
to the monitor.
2. Connect USB devices via other USB ports (downstream) on the monitor. These downstream
USB ports transmit data between connected USB devices and the upstream port.
to . Once the setting is done, unplug the current video cable
1.4 1.1
Basic menu operation on page
and
System DisplayPort
29.
How to assemble your monitor hardware
on the OSD menu
15