Keystone; Picture Orientation; Lamp Hours; System Reset - Runco DLC-2000HD Installation Manual

Liquid crystal projector & pixel-for-pixel controller with vivix technology

Hide thumbs Also See for DLC-2000HD:

Table of Contents

Keystone

In the event that the vertical lens shift feature does not provide enough vertical range for your

installation, the KEYSTONE feature allows you to correct for any trapezoidal (keystone) errors as a

result of angling the Projector to accommodate a large vertical offset. This will correct the keystone

effect up to +/- 15 degrees angle (from Projector level). See drawings below:

Image with keystone error

This will set the orientation of the image for your installation. If the Projector will be mounted on a

table, set this for Floor. If mounting it on the ceiling, select Ceiling. For two-mirror or 'straight-shot'

rear-screen applications, select floor rear or ceiling rear as appropriate.

Lamp Hours displays the number of hours the lamp has been on. With the DLC-2000HD, the lamp life

is around 1500 hours. This should be checked periodically to keep track of the lamp's age, and when

the lamp is around 1500 hours old, a new one should be installed to prevent lamp failure, including

implosion. You can access the lamp by removing the service panel on the bottom of the Projector.

In the event that your Controller appears to have a software problem, or adjustments have been

made so far out of range that the image is no longer on-screen or discernable, you can reset it back

to factory values. This sets ALL settings back to factory values, so any adjustments made previously

will be lost.

To reset your DLC-2000HD Controller, follow this procedure:

Turn off the MAIN POWER switch on the back of the processor

Hold down the DOWN ARROW button, and turn the MAIN POWER SWITCH back on.

Continue holding the down arrow button until the LED on the front panel blinks,

then release the down arrow button.

Once this is done, your processor has been completely reset to factory values. After resetting the unit,

Composite video will be the active source.

SYSTEM RESET is not on any of the menus; it must be performed using the instructions above.

Image with keystone corrected

Table of Contents