National Instruments SCXI Series Quick Start Manual page 2

The following symbols may be on your device.
This icon denotes a caution, which advises you of precautions to take to avoid injury, data loss, or a
system crash. When this symbol is marked on a product, refer to the Read Me First: Safety and
Electromagnetic Compatibility document, shipped with the device, for precautions to take.
When this symbol is marked on a product, it denotes a warning advising you to take precautions to avoid
electrical shock.
When this symbol is marked on a product, it denotes a component that may be hot. Touching this
component may result in bodily injury.
Step 2. Verify the Components
Make sure you have the specific combination of the SCXI system components, shown in Figures 1
and 2, needed for your application along with the following the following items:
• NI-DAQ 7.x or later software and documentation
• NI LabVIEW, NI LabWindows
Visual C++, or Visual Basic
• SCXI product manuals
• 1/8 in. flathead screwdriver
• Numbers 1 and 2 Phillips screwdrivers
• Wire insulation strippers
• Long nose pliers
1 1 1
1 Terminal Block or TBX Accessories (Optional)
2 PXI Module
3 SCXI Modules
1 Chassis Cord and Adapter Assembly
2 DAQ Device
SCXI Quick Start Guide
™
/CVI
SCX
I
114 0
2 2 2 3 3 3
Figure 1. SCXI System Components
And
1 2
Figure 2. For SCXI Chassis Only
™
, NI LabVIEW SignalExpress, NI Measurement Studio,
®
PO WE
R
RE SE
T
5
4
3
2
1
SC
MAI XI
NFR AME
4 4 4
4 PXI/SCXI Combination Chassis with Controller
5 SCXI Chassis
6 Chassis Power Cord
Or
3
3 USB Cable
4 SCXI USB Device
2
5 5 5 6 6 6
And
4
ni.com