Advertisement
1. Locknut (M6)
2. Brush rod
3. Spacer
6.
Repeat this procedure on the opposite side of
the machine.
Note:
There will be leftover locknuts.
Mounting the
Brush Brackets
Greensmaster 800/1000/2000 Models
only
1.
Position the machine on a level surface, engage
the parking brake, remove the key (if equipped)
and shut off the machine.
2.
Remove the 2 bolts and washers securing the
grass basket mounting rod to the left side plate
(Figure
4). Discard the bolts but retain the
washers.
Figure 3
4. Brush spring
5. Bolt (M6 x 40 mm)
g017161
1. Bolt
2. Washer
3.
Secure the grass basket mounting rod to the left
side plate with 2 new, fully threaded bolts (5/16
x 1-1/2 inches) and the 2 washers that were
previously removed
4.
Insert the left brush bracket onto the bolt and
secure it with 2 locknuts (5/16 inch) as shown
in
Figure
1. Level adjustment screw
2. Jam nut
Note:
The bracket is to be positioned so that
the hole in the bottom is to the front.
3
Figure 4
3. Grass basket mounting
rod
(Figure
5).
5.
Figure 5
3. Brush bracket
4. Locknut (5/16 inch)
g017162
g018504
Advertisement
