SEVERIN TO-2044 Instructions For Use Manual page 12

∙ The switch settings (upper heat/lower
heat) may be changed during the cooking
process.
∙ To interrupt the cooking process
temporarily, set the 7-position switch to
the ' ' position.
∙ Always use the door handle to open
the hot door after use. When removing
the baking tray or rack, use the handle
provided. Always place the tray and rack
down on a heat-resistant surface.
∙ After use, set the 7-position switch to the
' ' position and remove the plug from
the wall socket.
Using the hot-plates
∙ Always place a pot / saucepan on the
hot-plate fi rst.
∙ Large hot-plate:
Set the 7-position switch to the required
temperature.
∙ Small hot-plate:
Set the temperature control to the
required temperature.
∙ With one or both hot-plates switched on,
the indicator lamp is lit.
∙ Ensure that the pot is clean and dry on
the outside. Do not use stain covered or
sooty pots / saucepans.
∙ To prevent damage to the hot-plate, only
use pots / saucepans with fl at bottoms.
Most suitable are pots specifi cally
designed for use on electric plates (see
picture I).
∙ Always make sure that the pot / saucepan
used is of at least the same diameter
as the plate; this minimises the loss of
heat and prevents the plate from being
damaged as a result of uneven heat
distribution.
∙ After use, set the 7-position switch to the
12
' ' position (or the temperature control
to '0') and remove the plug from the wall
socket.
Cleaning and care
∙ Before cleaning the appliance, ensure it is
disconnected from the power supply and
has completely cooled down.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ Do not use abrasives, harsh cleaning
solutions or spray-type oven cleaners.
∙ The exterior housing and the door may be
cleaned with a damp, lint-free cloth.
∙ The baking tray and rack may be cleaned
using hot water and a mild detergent.
∙ After use, a wet cloth may be used to
remove any spills from the plates.
∙ Following a longer period of use, a special
commercially available cleaning agent
should be used to treat the plates.
Changing the bulb inside the oven
compartment
The bulb is located in the right-hand side
panel behind a glass plate.
∙ Allow the appliance to cool down.
∙ Remove the glass plate by turning it anti-
clockwise.
∙ Remove the defective bulb from its socket
by turning it anti-clockwise.
∙ Fit a new15V bulb (socket-type E14) into
the socket by turning it clockwise.
∙ Replace the glass plate and secure it by
turning clockwise.
Disposal
Devices marked with this symbol must be
disposed of separately from your household
waste, as they contain valuable materials