Installing The Protective Cover - Siemens FDM273-O Mounting

Mounting and installation
2

Installing the protective cover

2.4 Installing the protective cover
10 | 18
Building Technologies
Fire Safety
OUT OF ORDER
AUSSER BETRIEB
HORS SERVICE
FUORI SERVIZIO
FUERA DE SERVICIO
BUITEN GEBRUIK
Figure 3: 'NOT IN USE' label
If a protective cover (accessories) is used, proceed as follows:
w A compatible protective cover is available. See the chapter 'Accessories'.
1. Open the door of the manual call point.
2. Remove the glass insert. See the chapter 'Replacing the glass insert'.
3. Guide the protective cover (1) through the opening in the door from the front,
as shown in the diagram.
4. Insert the pivot pins (2) for the protective cover (1) in the two recesses on the
rear side of the door, as shown in the diagram.
5. Install the glass insert. See the chapter 'Replacing the glass insert'.
6. Close the door of the manual call point.
a The protective cover is inserted.
1
Figure 4: Example of installing protective cover DMZ1197-AC on a manual call point
1 Protective cover DMZ1197-AC
2 Pivot pin
2
A6V10425648_en--_f
2016-11-28