Advertisement
Operation
OPERATION
OPERATION
Setup and measurement procedure is as follows:
1. Set the instrument's cable LENGTH to 1m.
2. Connect the 16334A directly to the UNKNOUN terminals of the instrument.
3. Perform the ZERO offset adjustment described in the instrument's operation manual.
4. Connect the DUT to the 16334A test fixture.
DO NOT APPLY MORE THAN ± 42V OF DC BIAS VOLTAGE TO THE
WARNING
UNKNOWN TERMINALS. AN ELECTRICAL SHOCK HAZARD WILL EXIST
DURING OPERATION WHEN THE DC BIAS VOLTAGE IS GREATER THAN
± 42V DC.
Chapter 1
15
Advertisement
