Indesit HOTPOINT LUCE DX1032CX Service Manual page 34

Indesit Company
17) Inner & Centre Door Glasses
Remove the Inner Glass as Follows: -
Open the door fully and remove the top
extrusion, removing the screws from
both sides of the door.
Gently ease the top trim away from
the door, taking case not to lose the
metal angle brackets on the top
extrusion.
Gently ease the glass upwards
and remove from the door.
On replacing the inner glass panel it is
important that it is fitted the correct way
round with the heat reflective coating
toward the oven.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
18) Door Handle
1. Remove the door assembly as in 16).
2. Remove the inner door glass as in 17).
3. Separate the door glass from the inner panel.
4. Remove the 2 screws securing the handle to the door glass.
5. Reassemble in reverse order.
19) Sensor Probes
1. The sensor probes are located to the rear left of the oven cavities.
2. Remove the probe retaining screw in the oven cavity.
3. Remove the outer rear panel.
4. Remove the top panel as in 1).
5. Remove the cable tie in the control panel area to release the sensor wire.
6. Unclip the wire from the power board.
7. Pull the sensor forward through the oven cavity.
Service Manual UK
34 of 39
continued....
English