Table of Contents
Advertisement
VC73192MUK Rev6_Instruction Book 05/11/2012 16:34 Page 4
Operating / Assembly
Push the hose connector fully into the hose inlet
(17)
on the vacuum cleaner.
To remove, press the hose connector release
button
(16)
and pull out.
Always pull out the power cord
maximum length (indicated by the yellow tag
on the cable). Plug the appliance into the
mains supply. Push the On/Off button
start the motor.
IMPORTANT: Ensure that the appliance is
never left unattended whilst it is switched on.
When you have finished vacuum cleaning, switch
off the appliance. Remove the plug from the
mains supply and rewind the power cord
using the automatic cable rewind button (15).
WARNING: When using the automatic cable
rewind button, always hold the plug as the
power cord will rewind quickly.
4
1
Attach the extension tubes
attach them to the hose handle (1). Attach the
required accessory to the end of the lower tube.
3
Close
(4)
to its
The suction power can be varied to suit the
surface being cleaned by using the Eco Switch
(14), (see the table on page 5 for guideline
(3)
to
settings).
The suction power can also be adjusted using
the suction control on the hose handle (1).
Closed: full suction
Open:
5
To obtain the best results from your cleaner,
empty the dust canister
(4)
the airflow and cleaning power will be reduced.
Unplug the cleaner from the mains outlet.
1.
Disconnect the hose from the cleaner.
2.
Remove the dust canister from the cleaner by
3.
pushing the dust canister release latch (13).
(10)
together and
reduced suction
(18)
regularly, otherwise
2
4
Open
6
i
Advertisement
Table of Contents
