Table of Contents
Advertisement
VC700006 MUK Rev 1.qxp_Instruction Book 03/11/2014 14:49 Page 5
Operating / Assembly
Push the hose connector
inlet
(4)
on the vacuum cleaner.
To remove, squeeze the release buttons and
pull out.
Always pull out the power cord to its maximum
length. Plug the appliance into the mains supply.
Push the On/Off button
IMPORTANT: Ensure that the appliance is
never left unattended whilst it is switched on.
During short breaks in cleaning, the metal
telescopic tube
(17)
'standby' position. Rotate the combination floor
nozzle
(19)
or the turbo nozzle
on the neck can be fitted into the tube standby
slot on the rear of the appliance, whilst you
move furniture for instance.
1
(12)
fully into the hose
3
(9)
to start the motor.
5
can be held in an upright,
(21)
until the lug
The metal telescopic tube
(17)
in length by pressing down the telescopic tube
release button (16). When cleaning floors, the
telescopic tube should be fully extended and the
tube extension
(18)
should be fitted between the
hose handle
(15)
and the telescopic tube.
Attach the required accessory to the end of the
telescopic tube.
The suction power can be adjusted using the
suction power dial
(10)
or the suction control
on the hose handle (15).
Closed: full suction
Open:
reduced suction
When you have finished vacuum cleaning, switch
off the appliance. Remove the plug from the
mains supply and rewind the power cord using
the automatic cable rewind button (11).
WARNING: When using the automatic cable
rewind button, always hold the plug as the
power cord will rewind quickly.
2
may be adjusted
4
Close
Open
(14)
6
5
Advertisement
Table of Contents
