Alcatel OmniSwitch 7700 Hardware User's Manual page 78

Setting Up Power over Ethernet Hardware
5
Tighten the captive screw, located at the top of the power supply's front panel. Be sure not to over-
tighten the captive screw. If you use a screwdriver, the torque used to tighten the screw must not exceed
2.3 inch pounds.
6 Install all remaining power supplies by repeating steps 1 through 5 for each power supply.
7
Verify that the on/off switch for each installed power supply is in the off ( O ) position.
8
For each power supply, plug the power cord connector into the power supply socket and then plug the
power cord into an easily-accessible, properly grounded outlet or Uninterruptible Power Source (UPS). Be
sure that each power supply is plugged into its own dedicated AC outlet or power source; do not use an
extension cord or power strip.
Note. For information on removing power supplies, refer to
page 3-15.
page 3-14
Installing and Managing Power over Ethernet (PoE)
1
O K
A C
O K
D C
E R
O V
M P
T E
"Removing the Power Supplies" on
OmniSwitch 7700/7800 Hardware Users Guide
O K
A C
O K
D C
E R
O V
M P
T E
April 2005