Alcatel OmniSwitch 7700 Hardware User's Manual page 76

Setting Up Power over Ethernet Hardware
2
Attach the flanges to the power shelf using the Phillips-head screws provided. Be sure to tighten each
of the screws firmly using a Phillips screwdriver.
3 After both rack-mount flanges are secured to the unit, mark the holes on the rack where the power shelf
is to be installed.
4 Lift and position the power shelf until the rack-mount flanges are flush with the rack post.
5
Align the holes in the flanges with the rack holes that were marked in step 3.
6 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
D
P E S .
U IP 1
R D
E Q C O
LY
E P P
P LY T R IC S U
E C E R
O W IT .
U N
U T S
P E L E O U S
O N
R D N IR Z T
V E H E
R E N C
R A S
O N N
R D IO
A T E
C O N T IR N .
M E F A
D E IO
A T
N T A R
E P
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
7 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
page 3-12
3
2
OmniSwitch 7700/7800 Hardware Users Guide
Installing and Managing Power over Ethernet (PoE)
4
April 2005