Hot Swapping CMM Modules
Adding a Secondary CMM
A secondary (or redundant) CMM module can be added to the chassis at any time without disturbing the
operation of the switch. However, you should synchronize the primary and secondary CMMs immediately
after the hot swap in order to have effective redundancy. For more information, refer to
the Primary and Secondary CMMs" on page
Note. For detailed instructions on physically installing and removing modules (both NIs and CMMs), refer
to
Chapter 5, "Network Interface (NI) Modules."
page 4-12
4-10.
OmniSwitch 7700/7800 Hardware Users Guide
Chassis Management Module (CMM)
"Synchronizing
April 2005