Cisco 4000 Series Hardware Installation Manual page 103

Chapter 4 Configure Initial Router Settings on Cisco 4000 Series ISRs
Enter an enable password that is different from the enable secret password. This password is not
Step 6
encrypted (and is less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: cisco123
Enter the virtual terminal password, which prevents unauthenticated access to the router through ports
Step 7
other than the console port:
The virtual terminal password is used to protect
access to the router over a network interface.
Enter virtual terminal password: cisco
Respond to the following prompts as appropriate for your network:
Step 8
Configure SNMP Network Management? [no]: yes
Community string [public]:
A summary of the available interfaces is displayed.
Note
Current interface summary
Interface
GigabitEthernet0/0/0 unassigned
GigabitEthernet0/1/0 10.10.10.12
GigabitEthernet0/2/0 unassigned
SSLVPN-VIF0
Any interface listed with OK? value "NO" does not have a valid configuration
Respond to the following prompts as appropriate for your network:
Step 9
Configuring interface GigabitEthernet0/1/0:
Configure IP on this interface? [yes]: yes
IP address for this interface [10.10.10.12]:
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 10.0.0.0, 24 subnet bits; mask is /24
The following configuration command script was created:
hostname myrouter
enable secret 5 $1$t/Dj$yAeGKviLLZNOBX0b9eifO0 enable password cisco123 line vty 0 4
password cisco snmp-server community public !
no ip routing
!
interface GigabitEthernet0/0/0
shutdown
no ip address
!
interface GigabitEthernet0/1/0
no shutdown
ip address 10.10.10.12 255.255.255.0
!
interface GigabitEthernet0/2/0
shutdown
OL-32185-02
The interface summary includes interface numbering, which is dependent on the router model
and the installed modules and interface cards.
IP-Address
unassigned
Hardware Installation Guide for Cisco 4000 Series Integrated Services Routers
Perform Initial Configuration on Cisco 4000 Series ISRs
OK? Method Status
YES NVRAM administratively down down
YES DHCP up
YES NVRAM administratively down down
NO unset up
Protocol
up
4-3