Table of Contents
Advertisement
2.5 d
es C r i p t i o n
Proper installation of the mounting bracket enables the CSE 2800 head-end
station to be installed in a 19" cabinet as well as on a wall or upright stand-
ing.
The head-end station is modular in design and can be equipped with 8 stand-
ard plug-in modules and 8 add-on modules. A current list of the standard and
add-on modules can be found on the website "www.triax.com". This head-end
station is designed exclusively for use with these modules.
The various expansion options for the head-end station allow for the installa-
tion of a wide range of broadband cable systems.
Input SAT IF distributors and an output collector can be upgraded to offer the
highest degree of flexibility for the distribution of the signals.
The power supply in the CSE 2800 head-end station is designed to supply
power to components (e.g. LNB) connected upstream.
All RF output signals from the modules are combined via the inputs of a retro-
fitted active RF output collector and prepared for distribution through the RF
output socket.
When the head-end station is shipped from the factory, the default setting for
the control voltage for a RF output collector is maximum. If necessary please
set the master output level to the value required for the respective cable system.
When the head-end station is switched on, the two-line LC display shows the
"SETUP" menu and the software version of the control unit. The head-end sta-
tion output level can be adjusted in submenu "OUTPUT", the output standard
can be adjusted in submenu "NORM".
The operating software for the control unit and modules can be updated via
the 9-pin SUB-D socket of the head-end station using a PC or notebook and
the software "BE-Flash". Current versions of the software can be found on the
website "www.triax.com".
- 6 -
CSE 2800
Advertisement
Table of Contents
