Notes About Safety And Hazards - Triax CSE 2800 Assembly Instruction Manual

Table of Contents

Advertisement

1
n
otes
• The head-end station is subject to the regulations of protection class I.
• Never operate the device without a protective earth connection, earth con-
nection to the device and potential equalisation!
• The standards EN/DIN EN 50083 resp. IEC/EN/DIN EN 60728 must be
observed.
• Observe the relevant country-specific standards, regulations and guidelines
on the installation and operation of antenna systems.
• Replace mains cable and power supply unit only by original spare parts.
• Do not perform installation and service work during thunderstorms.
• Assembly, installation and servicing must be carried out by an authorised
electrician.
• Switch off the operating voltage of the system before beginning with as-
sembly or service work or pull out mains plug.
• The device should only be installed in a room where the permissible am-
bient temperature range of 0°C...+50°C can be maintained, even during
fluctuations in climatic conditions.
• To avoid too strong heating of the head-end station it is not admissible to
mount them one upon the other without using thermic precautions (e.g.
permanently air recirculation, ventilation, heat deflectors etc.).
• Do not install the device in cabinets or recesses which are not ventilated.
• If additional fans are to be used to circulate the air, ensure that the system
will be shut down (disconnected from mains) should any one of the fans fail.
• In case of the formation of condensation wait until the system is completely dried.
• Do not cover the ventilation openings!
• During installation, observe a minimum distance of
- 500 mm above/below and 75 mm behind the device at wall mounting,
- 500 mm above and 75 mm below/behind the device at upright mounting,
- 200 mm above/below and 100 mm behind the device at mounting in a
19" cabinet.
• Install the system ...
- on a vibration-free wall or floor construction
- In a dry, dust-free environment
- In such a manner that it is protected from moisture, fumes, splashing wa-
ter and dampness
- Where it is protected from direct exposure to sunlight
- Not within the immediate vicinity of heat sources
• Do not place any vessels containing liquids on the device.
• Do not place anything on the head-end station which could initiate fires
(e.g. candles).
a bo u t
sa fe t y
a n d
h a z a r ds
- 3 -
CSE 2800

Advertisement

Table of Contents
loading

Table of Contents