IBM SAN Volume Controller 2145-SV1 Hardware Installation Manual page 66

Figure 38. Opening the hinge brackets
7. Align the holes in the rail bracket with the holes on the front and rear rack cabinet flanges.
Ensure that the rails are aligned on the inside of the rack cabinet.
8. On the rear of the rail, press the two bracket pins into the holes in the rack flanges.
9. Close the rear hinge bracket to secure the rail to the rack cabinet flange.
(See Figure 39 on page 34.)
Figure 39. Closing the hinge brackets
10. On the front of the rail, press the two bracket pins into the holes in the rack flanges.
11. Close the front hinge bracket to secure the rail to the rack cabinet flange.
(See Figure 39 on page 34.)
12. Secure the rear of the rail to the rear rack flange with an M5 screw that is provided with the rack kit.
13. Repeat the steps to secure the opposite rail to the rack cabinet.
14. Repeat the procedure to install rails for each additional expansion enclosure.
34 SAN Volume Controller : Model 2145-SV1 Hardware Installation Guide