Dsp Parameter Definitions - Electro-Voice PXM‑12MP Series Installation Manual

18 en | Input panel and DSP
4.5

DSP parameter definitions

MODE - Adjusts the tuning preset applied to the output of the loudspeaker. There are four
modes available:
–
–
–
–
TREBLE - Used to adjust the high-frequency output of the system.
MID - Used to adjust the mid-frequency output of the system. This controls a set-Q parametric
EQ band whose center frequency is determined by the MID FREQ parameter. (Default 0dB)
MID FREQ - Adjusts the center frequency of the MID EQ band. (Default 1000Hz)
BASS - Used to adjust the low-frequency output of the system.
SUB - Enables a high-pass filter at the specified cut-off frequency. If using an Electro-Voice
subwoofer, select the appropriate model from the menu. If using other subwoofers, select the
appropriate generic high-pass frequency.
FEEDBACK - Enables and adjusts the center frequency of a narrow-Q notch filter. This can be
used in situations where there are specific frequencies that are causing the system to
feedback.
PHANTOM 1 and 2 - Activates a +15V phantom power supply on INPUT 1 and/or INPUT 2. This
is a sufficient voltage for use with most condenser microphones.
MIX OUT - Adjusts the routing and summation to the MIX OUT output. Adjust this parameter
when a stereo image is desired from two systems.
–
–
In both settings, the signals from INPUT 1 and INPUT 2 are also summed and routed to the MIX
OUT output.
DELAY - This parameter sets the amount of audio delay that will be applied before the signal
is output to the loudspeaker. This is useful for compensating the differences between
speakers at different distances from the listener. MIX OUT and THRU outputs are not affected.
2019-10 | v01 | F.01U.363.983
MONITOR 1 - Optimized for floor monitoring purposes. (Default)
MONITOR 2 - Secondary preset with more LF boost.
TRIPOD - Optimized for use while installed on a tripod or subwoofer pole.
GUITARCAB - Optimized for use as a guitar or bass guitar cabinet.
L + R - The LEFT and RIGHT signals of INPUT 3 are summed and output to both the
loudspeaker and the MIX OUT output.
R - The RIGHT signal of INPUT 3 is routed directly to the MIX OUT output. The
loudspeaker will only output the LEFT audio signal.
Installation manual
PXM-12MP Powered Monitor
Electro-Voice