Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. Do not expose this apparatus to dripping or splashing and ensure that no objects filled with liquids, such as vases, are placed on this apparatus.
Important Safety/Service Instructions ... 1 Plasma Series Owner’s Manual ... 2 Safety First ... 3 Description ... 4 System Features - Plasma ... 4 System Setup ... 4 P1 and P2 Amplifiers ... 5 Setup Diagrams for Plasma ... 7 Using Plasma P1’s as Floor Monitors ...
Safety First When setting up, installing and using Electro-Voice of precautions that you should follow: ® · When Electro-Voice Plasma speakers are used for portable applications in which they will be stacked directly on the floor, make sure that the floor or stage is solid and secure.
Description ® Electro-Voice Plasma high powered loudspeakers are fully integrated audio systems with carefully matched electronics and transducers. These products make it easy to setup a high- quality sound system quickly with a minimum of cables and external electronics. It retains typical EV ruggedness, reliability and impeccable sound quality.
P1 and P2 Amplifiers Input Electronically balanced inputs for the connection of high-level signal sources such as mixers, signal processors, etc. Establishing the connection is possible via phone or XLR-type jacks. Balanced connection is recommended to prevent noise or HF-interference. Caution: Before connecting or disconnecting any plugs, make sure to set the level control to its counterclockwise stop, which prevents the system,...
Page 7
Status Indicators These indicators provide information about the actual operational state of the Plasma’s internal power amplifier. Signal Indicates that an audio signal is present at the input and that it is output. Limit When lit this indicator signals that the internal power amplifier actually operated at the threshold of clipping.
Setup Diagrams for Plasma · Plug a line input into either the ¼-inch or the 3-pin XLR-type input connector. The ¼- inch input is in the center of the XLR connector and can accept unbalanced or balanced lines (TRS ¼-inch). The line input level required to drive the unit to full power is from –...
WARNING: Suspending any object is potentially dangerous and should only be attempted by individuals who have a thorough knowledge of the techniques and regulations of rigging objects overhead. Electro-Voice Plasma speakers be suspended taking into account all current national, federal, state and local regulations.
Suspending Plasma P1 Speaker Systems P1 enclosures have L-track located on the top, bottom, and on one side. Single or double stud ring fittings can be attached to the L-track to be used as suspension points. These points are located at the center of gravity to allow the system to hang straight when used either vertically, or horizontally.