4: Login Password Settings - Honeywell NOTIFIER ONYXWorks NFN Gateway Installation & Operation Manual

NFN Gateway Configuration Procedure
Step 8. Click in the Value field adjacent to Time Zone References field and then select from these
Step 9. Now you need to perform
3.4.4 Login Password Settings
The first time the gateway is started the factory default password is used (00000000 - eight zeros),
after the initial configuration it is highly recommended that you change the password.
Step 1. Select Tools >Set Gateway Password. The Gateway Login (change password) window
Step 2. Type in the current password in the Password field.
Step 3. Type in a new password in the New Password field.
Step 4. Type in the new password again in the Re-Enter New Password field.
Step 5. Click the OK button to complete the password change.
NFN Gateway Installation & Operation Manual - P/N: 52306:Rev: D 06/01/07
choices:
• US Standard - When selected the DST Begin and DST End settings are automatically
populated with the appropriate settings.
• EU Standard - When selected the DST Begin and DST End settings are automatically
populated with the appropriate settings.
• Custom - When selected you are require perform DST Begin and DST End settings.
Refer to "DST Begin/DST End" on page
"Login Password Settings" on page
displays.
Figure 3.12 Gateway Login - Change Password Window
• Passwords are case-sensitive.
• Alpha and numeric characters are supported.
• 1 character minimum and 8 character maximum.
You have completed "NFN Gateway Configuration"
these section in this order:
• "Configuration PC Preparation" on page
• "NFN Gateway Connection" on page
• "NFN Gateway Configuration Procedure" on page
NFN Gateway Configuration
41.
37.
if you followed the procedures in
30.
33.
34.
37