Rear Plate Unit - Canon PowerShot G2 Service Manual

CHAPTER 3. REPAIR INSTRUCTION
(1)-2
p
(1)-2
(1)-1
NOTE (Assembling)
When installing the REAR PLATE UNIT,
route the cable underneath the flexible
cable as shown in the illustration.

2.2.11 REAR PLATE UNIT

(1) REAR PLATE UNIT
1. Remove the two cables.
NOTE (Assembling)
When installing the REAR PLATE UNIT, route the cable underneath the flexible cable as shown in the
figure.
2. Remove the four screws.
3. Remove the two screws.
4. Peel off the two locations that are fixed by adhesive agent.
5. Remove the REAR PLATE UNIT.
NOTE (Assembling)
Attach the both-sided tape T-4000 on the BATTERY BOX side.
t
(1)-2
s
Fig. 3-14 REAR PLATE UNIT
p
REAR PLATE UNIT
(1)-3
REAR PLATE UNIT
NOTE (Assembling)
Attach the both-sided tape
T-4000.
3-14
n
(1)-3
(1)-5
(1)-4