Canon PowerShot G2 Service Manual page 63

CHAPTER 3. REPAIR INSTRUCTION
STEP 4
Insert a wire of φ1.2 mm into the hole A and the hole B, and lock the gear with the wire.
* When locking the gear, look into the viewfinder and confirm that the zoom lens is at
positioned at the wide end.
STEP 5
1. While maintaining the status of step 4, install
the FINDER UNIT into the OPTICAL UNIT.
2. Tighten the three screws.
3. Remove
the wire.
As the lens-barrel is protruded, turn ON then OFF
the main power of the camera after the camera is
completely re-assembled so that the lens-barrel is
retracted back to the main unit.
Fig. 3-18 Re-assembling method of the FINDER UNIT and OPTICAL UNIT-2
Hole B
Hole A
Wire of φ1.2 mm
< If the wire of φ1.2mm is not available >
Shaft
Remove the shaft (φ1.2mm) from another
FINDER UNIT and use the shaft. If the shaft
is removed from the FINDER UNIT once,
the FINDER UNIT cannot be used.
3-18
Another FINDER UNIT