Section 9. Communications Line Connection
Before you begin this section, the Verification Procedure in Section 8 of this
manual should have been completed.
1.
Set the Power switch on the IBM 5288 or 5285 to the 0 (Off)
position.
2.
Connect the communications cable that extends from the
back of the controller (5288 or 5285) as follows:
a. Determine the communications type (first) by looking at the end of
the communications cable and (second) by looking at the following
iIIu strations.
b. Once you have determined the communications type, go to the
appropriate step.
EIA Communications Line
Connected to
an
IBM 5285 or
5288
Modem
Wrap Connector
If you have the above communications type, go to step 3.
User's Setup Procedures
147