IBM 5280 User's Setup Manual page 129

122
49. Continue with the following steps if you have one or more
printers on your system. If you have no printers on your system,
go to step 56.
50. At each printer do the following:
a. Make sure the Power switch is turned on.
b.
Make sure the correct paper or forms are inserted.
c. Press the Stop switch, then the Start switch (if your printer has these
switches).
d. Make sure the Ready light is on (if your printer has the Ready light).
e. If the printer is connected to an IBM 5288 using the Cable Thru feature, do
the following:
1) Make sure that the input/output cables are connected properly. (These
connections are described under IBM 5288 Setup Procedure, steps 14
through 16.)
2) Make sure that the address switches are set correctly. (The switch
settings are described under IBM 5288 Setup Procedure, steps 17 and
18.)
3) Make sure that the terminator switches are set correctly. The termin-
ator switch on the last printer must be set to 1. All the others must
be set to 2. (The terminator switch settings are described under
IBM 5288 Setup Procedure, step 19.)
51. Move to keyboard 0 and do the following:
a. Insert the verification diskette into diskette drive 4000.
b. Key TPRNT after the words Program Name.
c. Press the Field+ or Field Exit key.
d. Key 4000 after the words Device address.
e. Press the Enter key.
52. Observe this display and do the following:
a. Key the printer machine number after the words Printer type.
You will find the printer type number on the machine name plate and the
printer address number on the four-digit label on the front cover of the
printer.
Machine Name Plate
IBM
XXXX Printer
Printer Type Number.
Four-Digit Label
Printer
Address