Care Of Drain Air Gap; Winterizing; Cleaning The Spray Arm - Frigidaire FDB2410HIB Servicing

Care of Drain Air Gap

If a drain air gap was installed for the dishwasher, check
to make sure it is clean so the dishwasher will drain
properly. A drain air gap is usually mounted on the
countertop and can be inspected by removing the cover.
This is not part of the dishwasher and is not covered by
warranty.

Winterizing

CAUTION
Freezing temperatures may cause water lines to
rupture. Be sure all supply lines to unit and circulating
lines within dishwasher are protected. Failure to do so
could result in property damage.
A dishwasher left in an unheated location should be
protected from freezing.
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the
supply source by removing fuses or tripping circuit
breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water
line from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water
into pan.
To Restore Service:
1. Reconnect the water, drain, and electrical power
supply.
2. Turn on water and electrical power supply.
3. Fill both detergent cups and run dishwasher through
a POTS & PANS cycle.
4. Check connections to make sure they do not leak.
Section 1 Basic Information

Cleaning the Spray Arm

The spray arm may need to be cleaned to insure that
there are no clogs to the spray arm jets and bearings
due to hard water chemicals.
To remove spray arm, simply hold the spray arm in place
and turn the retaining nut clockwise. Then pull up on
the spray arm lifting it off the shaft.
To clean the spray arm, use warm soapy water and a
soft brush to clean the jets and bearings.
To replace the spray arm, simply set the spray arm on
the shaft, take the retaining nut and turn it counter-
clockwise until it has locked into place.
Figure 1-4
1-7